LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (Heating & Air Conditioning (Service Information)) >> Controls >> Actuator, RECIRCULATION Door >> Removal >> Removal

Actuator, RECIRCULATION Door: Removal: Removal

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Refer to WARNING . Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

Fig 1: HVAC Housing Assembly & Recirculation Door Actuator
GC0089516Courtesy of CHRYSLER GROUP, LLC
  1. Remove the HVAC housing assembly. Refer to HOUSING, HVAC, REMOVAL .
  2. Remove the air inlet housing (1) and place it on a workbench. Refer to HOUSING, HVAC, REMOVAL .
  3. Remove the two screws (2) that secure the recirculation door actuator (3) to the air inlet housing and remove the actuator.
scientia non olet · About LEMON Manuals