Sensor, Crankshaft Position: Removal: Removal

WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Crankshaft Position Sensor

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate both of the negative battery cables.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Disconnect Crankshaft Position (CKP) sensor wire harness connector (1).

Fig 2: Crankshaft Position Sensor & Bolt
Courtesy of CHRYSLER GROUP, LLC
Remove bolt (2) and the CKP sensor (1).