Diagnosis And Testing - Noise: Vibration

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Vibration at the rear of the vehicle is usually caused by a:

Damaged drive shaft.
Missing drive shaft balance weight(s).
Worn or out-of-balance wheels.
Loose wheel lug nuts.
Worn U-joint(s).
Loose/broken springs.
Damaged axle shaft bearing(s).
Loose pinion gear nut.
Excessive pinion yoke run out.
Bent axle shaft(s).

Check for loose or damaged front-end components or engine/transmission mounts. These components can contribute to what appears to be a rear end vibration. Do not overlook engine accessories, brackets and drive belts.

NOTE:

All driveline components should be examined before starting any repair.