6.7L Diesel

WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate both of the negative battery cables.
Remove the left front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL .

Fig 1: Camshaft Position Sensor Wire Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the Camshaft Position (CMP) sensor wire harness connector (1).

Fig 2: Camshaft Position Sensor & Bolt
Courtesy of CHRYSLER GROUP, LLC
Remove the bolt (1) and the CMP sensor (2).

Fig 3: Camshaft Position Sensor & O-Ring
Courtesy of CHRYSLER GROUP, LLC
Check the condition of the O-ring seal (2) and replace if necessary.