Module, Integrated Trailer Brake (ITBM): Removal: Removal

WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering Column Opening Cover & Fasteners

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the battery negative cable.
Remove the steering column opening cover retaining screws (2).
Using a trim stick, remove the steering column opening cover (1) from the instrument panel and position aside.

Fig 2: Instrument Panel Side Cover
Courtesy of CHRYSLER GROUP, LLC
Using a trim stick, from the notch on the bottom, remove the left instrument panel side cover (1). May need to remove the door seal for better access to the side panel cover.

Fig 3: Identifying Integrated Trailer Brake Module (ITBM) Electrical Connectors
Courtesy of CHRYSLER GROUP, LLC
From under the instrument panel, disconnect the integrated trailer brake module (ITBM) electrical connectors (1).
NOTE:
One screw on the right front of the ITBM not shown.
Remove the ITBM retainer screws.
NOTE:
There is a retainer clip on each side of the ITBM near the bottom.
Using a trim stick, remove the ITBM from the IP.