LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1217 (6.4L Engine (Service Information) 2500 Hd & 3500 Hd) >> Engine Block >> Retainer, Crankshaft Rear Oil Seal >> Removal >> Removal

Retainer, Crankshaft Rear Oil Seal: Removal: Removal

WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Seal Retainer Removal/Tightening Sequence
GC0081773Courtesy of CHRYSLER GROUP, LLC
NOTE:

The crankshaft rear oil seal is integral to the crankshaft rear oil seal retainer and must be replaced as an assembly.

NOTE:

The crankshaft rear oil seal retainer can not be reused after removal.

NOTE:

This procedure can be performed in vehicle.

  1. Disconnect the negative battery cable.
  2. Remove the transmission. Refer to appropriate Transmission Service Information article.
  3. Remove the flexplate. Refer to FLEXPLATE, REMOVAL .
  4. Remove the oil pan. Refer to PAN, OIL, REMOVAL .
  5. Using the sequence shown in illustration, remove the rear oil seal retainer mounting bolts.
  6. Carefully remove the retainer from the engine block.
scientia non olet · About LEMON Manuals