Windshield Urethane Skip Repair

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: A-Pillar Windshield Molding

Courtesy of CHRYSLER GROUP, LLC

If the leak is determined to be adjacent to the windshield, then the A-Pillar windshield molding (1) should be removed. The windshield molding can be removed pulling it away from the cab at its four attach points (2), Refer to WEATHERSTRIP, WINDSHIELD, A-PILLAR, REMOVAL .

Fig 2: Exposed Body Seam
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Sealer skips or pinholes can be seen along the exposed body seams (1)

NOTE:
A special area of concern is where the windshield and body seams meet at the upper a-pillar (1), which is shown in illustration.
Once the windshield molding is removed, inspect for sealer skips. Apply Mopar Glass Sealer to any skip in the urethane around windshield.
For sealer skips in the A-Pillar body seam apply a Clear Hi-Flow Paintable Seam Sealer.
Prior to re-assembly, re-test the area to ensure it is properly sealed.
Carefully reinstall windshield molding. Refer to WEATHERSTRIP, WINDSHIELD, A-PILLAR, INSTALLATION .