LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Anti-Lock Brake System (Abs) (Service Information)) >> Standard Procedure >> Standard Procedure - Abs Brake Bleeding

Standard Procedure - Abs Brake Bleeding

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

ABS system bleeding requires conventional bleeding methods plus use of a scan tool. The procedure involves performing a base brake bleeding, followed by use of the scan tool to cycle and bleed the HCU pump and solenoids. A second base brake bleeding procedure is then required to remove any air remaining in the system.

  1. Perform base brake bleeding. Refer to STANDARD PROCEDURE . .
  2. Connect scan tool to the Data Link Connector.
  3. Select ANTILOCK BRAKES, followed by MISCELLANEOUS, then ABS BRAKES. Follow the instructions displayed. When scan tool displays TEST COMPLETE, disconnect scan tool and proceed.
  4. Perform base brake bleeding a second time. Refer to STANDARD PROCEDURE . .
  5. Top off master cylinder fluid level and verify proper brake operation before moving vehicle.
scientia non olet · About LEMON Manuals