LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Anti-Lock Brake System (Abs) (Service Information)) >> Electrical >> Sensor, Wheel Speed, Rear >> Removal >> Cab Chassis/4500/5500

Cab Chassis/4500/5500

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

All views typical.

Fig 1: Rear Wheel Speed Sensor
GC0108031Courtesy of CHRYSLER GROUP, LLC
1 - WHEEL SPEED SENSOR
2 - MOUNTING STUD
3 - AXLE HOUSING
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the brake line mounting nut and remove the brake line from the sensor stud.
  3. Remove the mounting stud (2) from the sensor (1) and shield.
  4. Remove the sensor (1) and shield from the differential housing (3).
  5. Disconnect the sensor wire harness and remove the sensor (1).
scientia non olet · About LEMON Manuals