LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1124 (Front Suspension & Wheel Alignment - 1500) >> Front, Independent Front Suspension >> Spring, Front Coil >> Removal >> 4X4-Coil Over

4X4-Coil Over

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Pliers On Chrome Machined Surface Of Shock/Strut Rod
GC0158072Courtesy of CHRYSLER GROUP, LLC
CAUTION:

Do not use any type of pliers on the chrome machined surface of shock/strut rod to assist in the disassembly/assembly of shocks or struts. Use only tools designed to hold the shock/strut rod stationary when servicing shock or strut components.

Fig 2: Shock Assembly & Stabilizer Link Lower Nut
GC0091569Courtesy of CHRYSLER GROUP, LLC
  1. Remove the shock (1). Refer to SHOCK ABSORBER, SUSPENSION, REMOVAL .
    Fig 3: Shock Assembly & Spring Compressor Tool
    GC0083207Courtesy of CHRYSLER GROUP, LLC
  2. Install the shock assembly (3) in the Branick 7200® spring removal/installation tool or equivalent (1).
  3. Compress the spring (2).
    Fig 4: Strut Nut Wrench & Mounting Plate
    GC0083208Courtesy of CHRYSLER GROUP, LLC
  4. Position Strut Nut Wrench (special tool #9362, Wrench, Strut Nut) (1), on shock shaft retaining nut. Next, insert 8 mm socket though Wrench onto hex located on end of shock shaft. While holding shock shaft from turning, remove nut from shock shaft using Wrench (1).
  5. Remove the upper shock nut.
    Fig 5: Upper Spring Isolator
    GC0091570Courtesy of CHRYSLER GROUP, LLC
  6. Remove the shock upper mounting plate.
  7. Remove the dust cover.
  8. Remove and inspect the upper spring isolator (2).
  9. Remove the shock.
scientia non olet · About LEMON Manuals