Arm, Upper Control: Installation: Installation
WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- Position the control arm (1) into the frame brackets. Install bolt (3) and nut (2), and tighten to specifications. Refer to FRONT, INDEPENDENT FRONT SUSPENSION, SPECIFICATIONS .
- Insert the ball joint in the steering knuckle (3) and tighten the upper ball joint nut (2) to specifications. Refer to FRONT, INDEPENDENT FRONT SUSPENSION, SPECIFICATIONS .
- Install the rotor to the hub.
- Install the disc brake caliper and adapter to the knuckle. Refer to ADAPTER, DISC BRAKE CALIPER, INSTALLATION .
- Install the wheel speed sensor wire to the upper control arm.
- Install the wheel and tire assembly. Refer to INSTALLATION .
- Remove the support and lower vehicle.
- Perform a wheel alignment. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .