Inner Tie Rod End

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Remove the outer tie rod end. Refer to END, TIE ROD, REMOVAL .
Remove the jam nut from the inner tie rod.

Fig 1: Clamps & Inner Tie Rod Boot
Courtesy of CHRYSLER GROUP, LLC
Remove the clamps (1, 2) for the inner tie rod boot (3).
Remove the boot (3) and discard.

Fig 2: Inner Tie Rod Socket
Courtesy of CHRYSLER GROUP, LLC
Install (special tool #10087-9, Socket, Inner Tie Rod) (1) onto the Inner Tie Rod.

Fig 3: Inner Tie Rod Adapter Wrench
Courtesy of CHRYSLER GROUP, LLC
Install (special tool #10087-2A, Adapter Wrench, Inner Tie Rod) (1) onto the Inner Tie Rod End.

Fig 4: EPS Steering Rack Holder
Courtesy of CHRYSLER GROUP, LLC
Install (special tool #10417, Holder, EPS Steering Rack) (1) onto the EPS Steering Rack on the non-screw side (Driver's Side) to prevent damage to the internal working of the EPS unit during loosening and remove the inner tie rod end.