LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1113 (Base Brakes (Service Information) 1500) >> Hydraulic/Mechanical >> Tubes And Hoses, Brake >> Removal >> Rear Brake Hose - 1500 Series

Rear Brake Hose - 1500 Series

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Left and right side procedures are similar.

  1. Install prop rod on the brake pedal to keep pressure on the brake system. Holding pedal in this position will isolate the master cylinder from the hydraulic brake system and will not allow brake fluid to drain out of the brake fluid reservoir while the brake lines are open. This will allow you to bleed out the area of repair instead of the entire system.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the tire and wheel assembly.
    Fig 1: Rear Brake Hose, Routing Clips, Flare Nut & Banjo Bolt
    GC0173527Courtesy of CHRYSLER GROUP, LLC
  4. Remove the wheel speed sensor harness from the routing clips (5) on the brake hose.
  5. Remove the banjo bolt (4) at the caliper.
  6. Disconnect the brake line flare nut (2) from the brake hose.
  7. Remove the brake hose retainer clip bolt (1) located at the frame.
  8. Remove the brake line (3).
scientia non olet · About LEMON Manuals