LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (3.0L Diesel (Service Information) 1500) >> Engine Mounting >> Insulator, Engine Mount, Right >> Removal >> 4X2 - Right

4X2 - Right

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
    Fig 1: Removing/Installing Engine Cover
    GC0158138Courtesy of CHRYSLER GROUP, LLC
  2. Remove the engine cover (1).
  3. Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL .
  4. Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
    Fig 2: CAC Hose & EGR Air Flow Control Valve
    GC0158047Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the CAC hose (1) from the EGR air flow control valve (2).
    Fig 3: Engine Lifting Special Tool VM.10360A-3 & Bolts
    GC0157996Courtesy of CHRYSLER GROUP, LLC
  6. Install the (special tool #VM.10360A-3, Bracket, Engine Lifting (Left Front)) (1) and securely tighten bolts (2).
  7. Assemble the (special tool #8534B, Fixture, Driveline Support) and support the engine.
  8. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  9. If equipped, removed the belly pan.
  10. Remove the left and right engine mount through bolt.
    Fig 4: Right Engine Mount, Bolts & Nuts
    GC0158041Courtesy of CHRYSLER GROUP, LLC
  11. Remove the right engine mount nuts (4).
  12. Remove the bolts (1, 3), nuts (4) and the right engine mount (2).
scientia non olet · About LEMON Manuals