LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Base Brakes (Service Information)) >> Hydraulic/Mechanical >> Junction Block, Brake Tube >> Installation >> Front Junction Block

Front Junction Block

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Junction Block, Brake Lines & Bolts
GC0087329Courtesy of CHRYSLER GROUP, LLC
  1. Position the junction block (2) on the frame.
  2. Install the junction block mounting bolts (3) and tighten to 19 N.m (169 in. lbs.).
  3. Install the eight brake lines (1) into the junction block (2) and tighten to 19 N.m (169 in. lbs.).
  4. Remove the supports and lower the vehicle.
  5. Remove the prop rod and bleed the base brake system. Refer to STANDARD PROCEDURE . .
scientia non olet · About LEMON Manuals