LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Base Brakes (Service Information)) >> Hydraulic/Mechanical >> Caliper, Disc Brake >> Removal >> Front

Caliper, Disc Brake: Removal: Front

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

1500 shown in illustration, others similar.

Fig 1: Identifying Disc Brake Caliper Components
GC0083369Courtesy of CHRYSLER GROUP, LLC
CAUTION:

Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable support to hang the caliper securely.

  1. Install prop rod on the brake pedal to keep pressure on the brake system, Holding pedal in this position will isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open. This will allow you to bleed out the area of repair instead of the entire system.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the tire and wheel assembly.
  4. Compress the disc brake caliper (6).
  5. Remove the banjo bolt (4) and discard the copper washers.
    Fig 2: Identifying Caliper Slide Pin Bolts
    GC0083370Courtesy of CHRYSLER GROUP, LLC
  6. Remove the caliper slide pin bolts (2).
    Fig 3: Brake Caliper & Adapter
    GC0091565Courtesy of CHRYSLER GROUP, LLC
  7. Remove the disc brake caliper (1) from the caliper adapter (2).
scientia non olet · About LEMON Manuals