Rear - Light Duty
WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - CALIPER ADAPTER |
| 2 - CALIPER ADAPTER MOUNTING BOLTS |
| 3 - CALIPER SLIDE BOLTS |
| 4 - BRAKE HOSE |
| 5 - PARK BRAKE CABLE |
| 6 - CALIPER |
| 7 - ROTOR |
| 8 - ANTI-RATTLE CLIPS |
- Install caliper (6) to the caliper adapter (1).
- Coat the caliper mounting slide pin bolts (3) with silicone grease. Then install and tighten the bolts to 30 N.m (22 ft. lbs.).CAUTION:
Verify that the brake hose is not twisted or kinked before tightening the fitting bolt.
NOTE:Install a new copper washers on the banjo bolt when installing
- Install the brake hose (4) to the caliper (6) with new copper washers and tighten fitting bolt to 28 N.m (245 in. lbs.).
- Remove the prop rod from the brake pedal.
- Bleed the area of repair for the brake system. If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed. . Refer to STANDARD PROCEDURE . .
- Install the wheel and tire assemblies. Refer to WHEELS, STANDARD PROCEDURE .
- Remove the supports and lower the vehicle.
- Verify a firm pedal before moving the vehicle.