LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Base Brakes (Service Information)) >> Hydraulic/Mechanical >> Adapter, Disc Brake Caliper >> Removal >> Front

Adapter, Disc Brake Caliper: Removal: Front

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Caliper Slide Pin Bolts
GC0083366Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the front wheel and tire assembly.
  3. Remove the caliper slide pin bolts (4). Refer to CALIPER, DISC BRAKE, REMOVAL .
    Fig 2: Brake Caliper & Adapter
    GC0091565Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable support to hang the caliper securely.

  4. Remove the disc brake caliper (1) from the adapter (2).
    Fig 3: Brake Pads, Caliper & Bolts
    GC0083367Courtesy of CHRYSLER GROUP, LLC
  5. Remove the inboard (4) and outboard (2) brake pads.
  6. Remove the caliper adapter mounting bolts (5).
  7. Remove and transfer any necessary components.
scientia non olet · About LEMON Manuals