5.7L Engine

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Refer to the applicable Warnings Plumbing , Warning and Cautions Plumbing , Caution for this system before performing the following operation. Failure to follow these instructions may result in possible serious or fatal injury.

Fig 1: A/C Discharge & Liquid Lines

Courtesy of CHRYSLER LLC

Disconnect and isolate the negative battery cable.
Recover the refrigerant from the refrigerant system. Refer to Plumbing , Standard Procedure .
Remove the nut (2) that secures the A/C discharge line (3) to the condenser jumper line tapping block (1).
Disconnect the A/C discharge line from the condenser jumper line tapping block.

Fig 2: Accessory Drive Belt
Courtesy of CHRYSLER LLC
Remove the nut (2) that secures the A/C discharge line (3) to the A/C compressor (4).
Disconnect the A/C discharge line from the A/C compressor.

Fig 3: Refrigerant Lines
Courtesy of CHRYSLER LLC

NOTE:
Illustration shown with refrigerant lines removed for clarity.
Disconnect the wire harness connector from the A/C pressure transducer (4).
Remove the two plastic retaining brackets (2 and 3) that secure the A/C discharge line (5) to the A/C suction line (1) and to the upper front of the engine.
Remove the A/C discharge line from the engine compartment.
Remove and discard the O-ring seals and gaskets from the A/C discharge line and install plugs in, or tape over the opened discharge line fittings and the jumper line and compressor ports.
If necessary, remove the A/C pressure transducer from the A/C discharge line. Refer to TRANSDUCER, A/C Pressure , Removal .