LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Heating & Air Conditioning (Service Information)) >> Plumbing >> LINE, A/C Discharge >> Installation >> 3.7L/4.7L Engines

3.7L/4.7L Engines

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system. Refer to OIL, Refrigerant , Standard Procedure . Failure to properly adjust the refrigerant oil level will prevent the A/C system from operating as designed and can cause serious A/C compressor damage.

NOTE:

When replacing multiple A/C system components, refer to OIL, Refrigerant , Standard Procedure  to determine how much oil should be added to the refrigerant system.

NOTE:

Replacement of the refrigerant line O-ring seals and gaskets is required anytime a refrigerant line is disconnected. Failure to replace the rubber O-ring seals and metal gaskets could result in a refrigerant system leak.

Fig 1: A/C Discharge Line
GC0089597Courtesy of CHRYSLER LLC
NOTE:

4.7L engine shown in illustration. 3.7L engine similar.

  1. If removed, install the A/C pressure transducer (2) onto the A/C discharge line (4). Refer to TRANSDUCER, A/C Pressure , Installation .
  2. Remove the tape or plugs from the opened discharge line fitting and the compressor and condenser jumper line ports.
  3. Lubricate new O-ring seals with clean refrigerant oil and install them and new gaskets onto the discharge line fitting. Use only the specified O-ring seals as they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
  4. Connect the A/C discharge line to the condenser jumper line tapping block (3) and install the nut (1). Tighten the nut to 23 N.m (17 ft. lbs.).
  5. Connect the A/C discharge line to the A/C compressor (5) and install the nut (6). Tighten the nut to 23 N.m (17 ft. lbs.).
  6. Connect the wire harness connector to the A/C pressure transducer.
  7. Reconnect the negative battery cable.
  8. Evacuate the refrigerant system. Refer to Plumbing , Standard Procedure .
  9. Adjust the refrigerant oil level. Refer to OIL, Refrigerant , Standard Procedure .
  10. Charge the refrigerant system. Refer to Plumbing , Standard Procedure .
scientia non olet · About LEMON Manuals