LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Heating & Air Conditioning (Service Information)) >> Plumbing >> Compressor, A/C >> Diagnosis and Testing >> A/C Clutch Coil >> Coil Resistance Test

Coil Resistance Test

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Disconnect the wire harness connector from the A/C clutch coil connector.
  3. Use an ohm meter and Back Probe Tool (special tool #6801, Terminal Probe) and measure the resistance of the A/C clutch coil at the coil connector terminals.
  4. See A/C Clutch Coil Specifications table for acceptable A/C clutch coil resistance. Specifications apply for a work area temperature of 21° C (70° F).
    1. If the A/C clutch coil reading is below specifications, the coil is shorted and must be replaced.
    2. If the A/C clutch coil reading is above specifications, the coil is open and must be replaced.
scientia non olet · About LEMON Manuals