Electronic Display Unit

When the status of the ignition switch is OFF, the electronic display unit is inactive and the total odometer information is displayed only when the driver side front door is open and is deactivated when the driver side front door is closed. Otherwise, the display unit is only active and the total odometer information is only displayed when the status of the ignition switch is ON/RUN or Accessory (ACC), and is inactive when the status of the ignition switch is OFF.

• Odometer/Trip Odometer Display Toggling  - Momentarily actuating the appropriate push button within the odometer switch pod or the EVIC switch pod (depending on how equipped) with the electronic display unit active, will toggle the display between the total odometer and trip odometer information.
• Trip Odometer Reset  - Actuating the appropriate push button within the odometer switch pod or the EVIC switch pod (depending on how equipped) for longer than about two seconds while the status of the ignition switch is ON will reset the active trip odometer (A or B) to 0.0  kilometers (miles). Only the trip odometer information being currently displayed (active) will be reset.
• Communication Error  - If the IC fails to receive an electronic distance  message during normal operation, it will hold and display the last data received until the status of the ignition switch is OFF. If the IC does not receive a distance  message within one second after the ignition switch status transitions to ON, it will display the last distance value stored in IC memory. If the IC is unable to display distance information due to an error internal to the IC, the electronic display unit will display Error  .
• Self Test  - Each time the IC is put through the self diagnostics test, the electronic display unit will illuminate all of its segments simultaneously to confirm the functionality of the display and the IC control circuitry.