Shaft, Drive, Front Light Duty: Installation: Installation

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Propeller Shaft & Pinion Flange Reference Mark

Courtesy of CHRYSLER GROUP, LLC

Install propeller shaft with all reference marks (4) aligned.
Install with dust boot clamp at transfer case end.
NOTE:
Drive shaft bolts must be replaced or cleaned and Mopar® Lock and Seal Adhesive or equivalent applied.
Install axle companion flange bolts and tighten to 115 N.m (85 ft. lbs.).
Install skid plate, if equipped.