Pressure Hose
WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - LOWER COUPLING BOLT |
| 2 - HIGH PRESSURE HOSE |
| 3 - RETURN HOSE |
| 4 - STEERING GEAR |
| 5 - PITMAN ARM |
NOTE:
Be sure to align the pressure hose so it does not contact the fan shroud or the frame rail.
- Install the pressure hose to the vehicle.
- Reconnect the pressure hose (2) at the gear (4). Tighten the hose to 32 N.m (23 ft. lbs.) .
- Reconnect the pressure hose at the pump. Tighten the hose to 36 N.m (27 ft. lbs.).
- Remove the support and lower the vehicle.
- Refill the power steering system. Refer to PUMP, STANDARD PROCEDURE .