RH - Drag Link To Tie Rod

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

All views typical.

Fig 1: Link And Coil Steering System Components

Courtesy of CHRYSLER GROUP, LLC

Install the tie rod (6) into the adjuster sleeve (7) and into the steering knuckle.
Install the drag link (2) to the tie rod (6). Install the nut (10) and tighten to specifications. Refer to LINKAGE, LINK AND COIL, SPECIFICATIONS .
Install the wheels as necessary. Refer to WHEELS, STANDARD PROCEDURE .
Remove the supports and lower the vehicle. Center the steering wheel and adjust the toe. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
NOTE:
Position the clamp on the sleeve so retaining bolt is located on the bottom side of the sleeve.
After adjustment tighten tie rod adjustment sleeve clamp bolts to specifications. Refer to LINKAGE, LINK AND COIL, SPECIFICATIONS .