Bracket - 2500/3500

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

All views are typical.

Fig 1: Identifying Steering Damper & Linkage Bracket Bolt

Courtesy of CHRYSLER GROUP, LLC

Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Remove the steering damper mounting nut (6) at the linkage bracket (3) and position the steering damper (1) off the retaining bolt (7).

NOTE:

Some vehicles may have only one u-bolt retaining the bracket to the tie rod.

Remove the four (or two) mounting bracket u-bolt nuts (5) and remove the bracket (3).