LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Steering System) >> Linkage, Independent Front Suspension >> End, Tie Rod >> Removal >> Outer Tie Rod End

Outer Tie Rod End

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Outer Tie Rod End, Jam Nut & Separator
GC0083619Courtesy of CHRYSLER GROUP, LLC
NOTE:

Do not twist the boot anytime during removal or installation.

  1. Loosen the jam nut (3).
  2. Remove the outer tie rod end nut from the ball stud.
  3. Separate the tie rod ball stud (1) from the knuckle with Ball Joint Remover (special tool #9360, Remover, Ball Joint) (2) .
  4. Unthread the outer tie rod end (1) from the inner tie rod.
scientia non olet · About LEMON Manuals