LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Steering System) >> Linkage, Independent Front Suspension >> End, Tie Rod >> Removal >> Inner Tie Rod End

Inner Tie Rod End

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Outer Tie Rod End, Jam Nut & Separator
GC0083619Courtesy of CHRYSLER GROUP, LLC
  1. Remove the outer tie rod end (1) Count the number of turns when removing, this will aid in setting the toe after installation.  . Refer to END, TIE ROD, REMOVAL .
  2. Remove the jam nut (3).
    Fig 2: Boot & Clamps
    GC0083620Courtesy of CHRYSLER GROUP, LLC
  3. Remove the clamps (1, 3) for the inner tie rod boot (2).
  4. Remove the boot (2).
    Fig 3: Identifying Socket & Tube
    GC0083621Courtesy of CHRYSLER GROUP, LLC
  5. Install Inner Tie Rod Wrench (special tool #10087-3, Wrench, Inner Tie Rod) (2) and Inner Tie Rod Adapter Wrench (special tool #10087-2A, Adapter Wrench, Inner Tie Rod) (1) and remove the inner tie rod end.
scientia non olet · About LEMON Manuals