LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Steering System) >> Column >> Shroud, Steering Column >> Removal >> Lower

Shroud, Steering Column: Removal: Lower

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Steering Column Shroud
GC0088328Courtesy of CHRYSLER GROUP, LLC
  1. From below the steering column, remove the two outboard screws within the recess areas (2) that secure the upper shroud (1) to the lower shroud (4).
    NOTE:

    There are snap connections near the instrument cluster and between the shroud and the steering wheel that secure the upper and lower shroud.

  2. Remove the upper shroud (1) by pushing gently inward and upward on both sides of the upper shroud above the parting line of the lower shroud to release the snap features that secure the two shroud halves to each other.
  3. Remove the steering column opening cover from the instrument panel. Refer to COVER, STEERING COLUMN OPENING, REMOVAL .
    Fig 2: Steering Column Lower Shroud
    GC0088329Courtesy of CHRYSLER GROUP, LLC
  4. Remove the lower shroud to column retaining screw (2) and carefully move the lower shroud over the steering column tilt lever and off the steering column.
scientia non olet · About LEMON Manuals