LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Front Suspension & Wheel Alignment) >> Front, Link And Coil >> Link, Stabilizer Bar >> Removal >> Stabilizer Link With Disconnecting Stabilizer Bar

Stabilizer Link With Disconnecting Stabilizer Bar

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Stabilizer Link, Nuts & Stabilizer Bar
GC0107552Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle.
  2. Hold the stabilizer link (1) shafts with a wrench and remove the link nuts (3) at the stabilizer bar (2).
    Fig 2: Removing Links From Axle Brackets
    GC0107553Courtesy of CHRYSLER GROUP, LLC
  3. Remove the stabilizer bar link nuts from the axle brackets (2).
  4. Remove the links (1) from the axle brackets (2) with Puller (special tool #9360, Remover, Ball Joint) (3) .
scientia non olet · About LEMON Manuals