LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Front Suspension & Wheel Alignment) >> Front, Link And Coil >> Link, Stabilizer Bar >> Installation >> With Disconnecting Stabilizer Bar

With Disconnecting Stabilizer Bar

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Stabilizer Link, Nuts & Stabilizer Bar
GC0107552Courtesy of CHRYSLER GROUP, LLC
  1. Install links (1) to the axle bracket (5) and tighten nut (4) to specifications. Refer to SPECIFICATIONS . .
  2. Install links (1) and nuts (3) to the stabilizer bar (2). Hold the link shaft with a wrench and tighten the nuts to specifications. Refer to SPECIFICATIONS . .
  3. Remove the supports and lower the vehicle.
scientia non olet · About LEMON Manuals