LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Front Suspension & Wheel Alignment) >> Front, Link And Coil >> Knuckle, Steering >> Removal >> 2500, 3500

2500, 3500

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hub bearing. Refer to HUB AND BEARING, REMOVAL .
  2. Remove tie-rod or drag link end from the steering knuckle arm.
  3. Remove the wheel speed sensor. Refer to SENSOR, WHEEL SPEED, FRONT, REMOVAL .
  4. Loosen the upper ball stud nut.Do not remove the nut at this time. 
  5. Remove the lower ball joint nut.
    Fig 1: Separating Lower Ball Joint
    GC0107544Courtesy of CHRYSLER GROUP, LLC
  6. Separate the lower ball joint (4) using Ball Joint Press (special tool #C-4150A, Press, Ball Joint) (3).
  7. Remove the upper ball joint nut.
  8. Remove the steering knuckle (2).
scientia non olet · About LEMON Manuals