LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Front Suspension & Wheel Alignment) >> Front, Link And Coil >> Knuckle, Steering >> Installation >> 2500, 3500

2500, 3500

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the steering knuckle on the ball studs.
  2. Install and tighten lower ball stud nut to initial torque  specifications. Refer to SPECIFICATIONS . .
  3. Install and tighten upper ball stud nut to specifications. Refer to SPECIFICATIONS . .
  4. Re-torque lower ball stud nut to final torque  specifications. Refer to SPECIFICATIONS . .
  5. Install the hub bearing. Refer to HUB AND BEARING, INSTALLATION .
  6. Install tie-rod or drag link end onto the steering knuckle arm and tighten to specifications. Refer to SPECIFICATIONS . .
  7. Install the wheel speed sensor. Refer to SENSOR, WHEEL SPEED, FRONT, INSTALLATION .
scientia non olet · About LEMON Manuals