LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Front Suspension & Wheel Alignment) >> Front, Link And Coil >> Hub And Bearing >> Removal >> 4500 And 5500

4500 And 5500

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the wheel and tire assembly.
  3. Remove the brake caliper. Refer to CALIPER, DISC BRAKE, REMOVAL .
  4. Remove the caliper adapter. Refer to ADAPTER, DISC BRAKE CALIPER, REMOVAL .
    Fig 1: Disc Brake Rotor, Hub Extension & Axle Shaft Nut
    GC0107539Courtesy of CHRYSLER GROUP, LLC
  5. Remove the hub extension (2) and disc brake rotor (1). Refer to ROTOR, BRAKE, REMOVAL .
  6. Remove the axle shaft nut (3) from the axle shaft.
    Fig 2: Wheel Speed Sensor & Bolt
    GC0107540Courtesy of CHRYSLER GROUP, LLC
  7. Disconnect the wheel speed sensor wire and remove the wheel speed sensor bolt (1) from the hub/bearing then remove the sensor (2).
    Fig 3: Hub/Bearing Bolts
    GC0107541Courtesy of CHRYSLER GROUP, LLC
  8. Remove the hub/bearing 4 mounting bolts (1) and remove the hub/bearing.
scientia non olet · About LEMON Manuals