LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Front Suspension & Wheel Alignment) >> Front, Link And Coil >> Hub And Bearing >> Removal >> 2500, 3500

2500, 3500

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the wheel and tire assembly.
    Fig 1: Hub Extension
    GC0107537Courtesy of CHRYSLER GROUP, LLC
  3. Remove the hub extension (1) mounting nuts and remove the extension from the rotor if equipped.
    Fig 2: Hub Nut Cotter Pin
    GC0107538Courtesy of CHRYSLER GROUP, LLC
  4. Remove the brake caliper. Refer to CALIPER, DISC BRAKE, REMOVAL .
  5. Remove the cotter pin (2) and the hub nut (1) from the axle shaft.
  6. Remove the caliper adapter. Refer to ADAPTER, DISC BRAKE CALIPER, REMOVAL .
  7. Remove the disc brake rotor. Refer to ROTOR, BRAKE, REMOVAL .
  8. Disconnect the wheel speed sensor wire.
  9. Remove the hub/bearing 4 mounting bolts and remove the hub/bearing.
scientia non olet · About LEMON Manuals