2500, 3500
WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - SPECIAL TOOL C4212F |
| 2 - SPECIAL TOOL 8975-1 |
| 3 - BALL JOINT |
| 4 - KNUCKLE |
| 5 - SPECIAL TOOL 8975-3 |
- Position Ball Joint Remover/Installer (special tool #8975-1, Installer, Ball Joint) (DRIVER) (2) and Ball Joint Remover/Installer (special tool #8975-3, Cup, Remover) (RECEIVER) (5) with Ball Joint Press (special tool #C-4212F, Press, Ball Joint) (1) as shown in illustration to install lower ball stud (3).
- Install the axle shaft into the axle. Refer to INSTALLATION or INSTALLATION .
- Install the steering knuckle. Refer to KNUCKLE, STEERING, INSTALLATION .