LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Front Suspension & Wheel Alignment) >> Front, Link And Coil >> Arm, Upper Control >> Removal >> Right

Arm, Upper Control: Removal: Right

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exhaust Removal
GC0107520Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle.
  2. Support the axle.
  3. Disconnect the exhaust system at the manifold(s) (1).
  4. Disconnect the exhaust bracket (4) at the transmission.
  5. Disconnect the rubber exhaust mounts for the exhaust.
  6. Raise the exhaust system up and back in order to gain access to the removal of the upper bolt (3).
    Fig 2: Upper & Lower Control Arm Bolts
    GC0107521Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Discard the nuts and bolts and do not reuse. New nuts and bolts should be used when replacing or servicing the control arms.

  7. Remove the nut (1) and bolt at the frame rail and remove the upper control arm (2).
  8. Remove the upper control arm nut and bolt at the axle bracket.
  9. Remove the control arm (2) from the vehicle.
scientia non olet · About LEMON Manuals