LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (6.7L Diesel - Mil Light On Pretest Procedure, Diesel AFTERTREATMENT Validation, Pre-Diagnostic Troubleshooting Procedure, Pcm/ECM/TCM Programming, Powertrain Verification Test & Intermittent Condition - 3500 Cab & Chassis, 4500 & 5500) >> Standard Procedure >> Pcm/ECM / TCM Programming >> Section 2 - Additional Pcm/ECM / TCM Replacement Procedures >> If a 3.0L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:

If a 3.0L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:

WARNING: This page is about a different car, the 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The available routines may vary depending on model and year of vehicle.

  1. PCM/ECM Replaced - Located within the Security Module
  2. ECU Replacement With Value Transfer - if the ECU to be replaced is still responsive
    NOTE:

    If the PCM/ECM data transfer is able to be completed, it may not be necessary to perform routines 7 - 12.

  3. ECU Replacement Without Value Transfer - if the ECU to be replaced is NOT responsive
  4. Injector Quantity Adjustment
  5. Program Variant Code
  6. Verify PCM/ECM VIN
  7. Diesel Particulate Filter (Used) Learning
  8. Reset of Lambda Values
  9. Reset Zero Fuel
  10. NOx Catalyst (New) Initialization
  11. IMA Rapid Calibration Test
  12. Fuel Mean Value Adaptation Initialization
  13. Exhaust Throttle Plate Adaptive Learn Position
scientia non olet · About LEMON Manuals