LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (6.7L Diesel - Mil Light On Pretest Procedure, Diesel AFTERTREATMENT Validation, Pre-Diagnostic Troubleshooting Procedure, Pcm/ECM/TCM Programming, Powertrain Verification Test & Intermittent Condition - 3500 Cab & Chassis, 4500 & 5500) >> Standard Procedure >> Pcm/ECM / TCM Programming >> Section 2 - Additional Pcm/ECM / TCM Replacement Procedures >> If a 2.0L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:

If a 2.0L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:

WARNING: This page is about a different car, the 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The available routines may vary depending on model and year of vehicle.

  1. PCM/ECM Replaced - Located within the Security Module
  2. ECU Replacement With Value Transfer - if the ECU to be replaced is still responsive
    NOTE:

    If the PCM/ECM data transfer is able to be completed, it may not be necessary to perform routines 7 - 9.

  3. ECU Replacement Without Value Transfer - if the ECU to be replaced is NOT responsive
  4. Verify PCM/ECM VIN
  5. Injector Quantity Adjustment
  6. Program Variant Code
  7. Service Diesel Particulate Filter Regeneration
  8. Reset Zero Fuel
  9. Reset of Lambda Values
scientia non olet · About LEMON Manuals