LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (3.6L Engine (Service Information)) >> Cylinder Head >> ROCKER ARM, Valve >> Removal >> Removal

ROCKER ARM, Valve: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:

The LH cylinder head rocker arms are shown in illustration, the RH cylinder head rocker arms are similar.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the camshaft(s). Refer to CAMSHAFT, Engine , Removal .
    NOTE:

    If the rocker arms are to be reused, identify their positions so that they can be reassembled into their original locations.

    Fig 1: Locating Rocker Arm
    GC0144231Courtesy of CHRYSLER LLC
  3. Remove the rocker arm(s) (1).
scientia non olet · About LEMON Manuals