LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 941 (Integrated Trailer Brake Module (ITBM) - Electrical Diagnostics - 2500 Hd & 3500 Hd) >> Diagnosis And Testing >> C2214-00-ITBM Not Calibrated >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

INTEGRATED TRAILER BRAKE MODULE (ITBM) NOT CALIBRATED 

  1. The ITBM is reporting internal errors.
    NOTE:

    Before continuing, check the ITBM harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.

  2. Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all power and ground circuits.
  3. Perform any Technical Service Bulletins (TSB)s that may apply.

    Were there any problems found?

    Yes 

    No 

    • Replace the Integrated Trailer Brake Module (ITBM) in accordance with the Service Information.
    • Perform the ITBM VERIFICATION TEST. Refer to STANDARD PROCEDURE .