Sensor, Crankshaft Position: Removal: Removal
WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - CYLINDER BLOCK - RIGHT / REAR |
| 2 - ELEC. CONNECTOR |
| 3 - MOUNTING BOLT |
| 4 - CKP SENSOR |
The Crankshaft Position (CKP) sensor (4) is located at the right-rear side of the engine cylinder block. It is positioned and bolted into a machined hole in the engine block.
- Raise vehicle.
- Disconnect CKP electrical connector at sensor.
- Remove CKP mounting bolt (3).
- Carefully twist sensor (4) from cylinder block.
- Remove sensor from vehicle.
- Check condition of sensor O-ring.