Switch, Seat, Power: Installation: Installation

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Driver side shown in illustration. Passenger side similar.

Fig 1: Power Seat Switch Bezel & Power Seat Switch

Courtesy of CHRYSLER GROUP, LLC

Connect the electrical connector (1) to the power seat switch (3). Make sure the connector is fully engaged to the switch.
Position the power seat switch to the seat switch bezel (4).
Engage the four retaining tabs (2) that secure the power seat switch to the bezel. Make sure the tabs are fully engaged.

Fig 2: Seat Switch Bezel & Seat Cushion Side Trim Panel
Courtesy of CHRYSLER GROUP, LLC

Fig 3: Seat Switch Bezel, Seat Cushion Side Trim Panel & Tabs
Courtesy of CHRYSLER GROUP, LLC
Engage the retaining tab (4) at the front of the seat switch bezel (2) to the seat cushion side trim panel (3).
Carefully engage the remaining seven retaining tabs (1) that secure the seat switch bezel to the seat cushion side trim panel. Start at the front of the switch bezel and work rearward. Make sure all eight retaining tabs are fully engaged.

Fig 4: Lumbar Control Switch Electrical Connector & Seat Wire Harness
Courtesy of CHRYSLER GROUP, LLC
Connect the lumbar control switch electrical connector (1) to the seat wire harness (2).
Reconnect the negative battery cable.
Verify proper power seat operation.