Sensor, Camshaft Position: Removal: 6.4L

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The Camshaft Position Sensor (CMP) is located on right side of engine timing cover.

Disconnect and isolate the negative battery cable.
Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL, 6.4L .

Fig 1: Identifying Wire Harness Connector Release Tab
Courtesy of CHRYSLER GROUP, LLC
Clearance is minimal between the timing cover and the release tab (2) on the wire harness connector, using a pick (1) or equivalent will ensure the proper removal of the wire harness connector.

Fig 2: Identifying Wiring Harness Connector And CMP Sensor
Courtesy of CHRYSLER GROUP, LLC
Remove the wire harness connector (1) from the CMP sensor using a pick (2) or equivalent and position aside.

Fig 3: Locating CMP Sensor
Courtesy of CHRYSLER GROUP, LLC
Remove CMP sensor mounting bolt (2).
Pull the CMP sensor (1) straight out of the timing cover, twist slightly if necessary.
Check condition of sensor O-ring seal.