LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 892 (Charging (Service Information) 2500 Hd & 3500 Hd) >> Generator >> Removal >> 6.7L Diesel-Dual

6.7L Diesel-Dual

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Disconnect both negative cables from both batteries before removing battery output wire (B+ wire) from generator. Failure to do so can result in injury or damage to electrical system.

  1. Disconnect both negative battery cables.
  2. Remove engine oil dipstick.
  3. Remove fasteners and the engine cover.
  4. Remove the serpentine drive belt. Refer to BELT, SERPENTINE, REMOVAL .
  5. Partially drain the cooling system. Refer to STANDARD PROCEDURE .
  6. Disconnect the upper radiator hose at the radiator.
  7. Remove bolt and the upper radiator hose support bracket.
  8. Disconnect field wire connector (3) from the generator.
  9. Unsnap plastic insulator cap (1) from B+ output terminal.
  10. Remove nut (2) and the B+ cable (1) from generator.
    Fig 1: Generator & Bolt
    GC0157535Courtesy of CHRYSLER GROUP, LLC
  11. Remove bolts (2) and the generator (1) from engine.
    Fig 2: Lower Generator Mounting Bracket Bolts
    GC0157538Courtesy of CHRYSLER GROUP, LLC
  12. If necessary, remove the lower generator mounting bracket bolts (1).
    Fig 3: Generator Mounting Bracket & Bolt
    GC0157539Courtesy of CHRYSLER GROUP, LLC
  13. If necessary, remove bolts (1) and the generator mounting bracket (2).
scientia non olet · About LEMON Manuals