6.4L - Dual

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Disconnect the negative cable from the battery before removing the battery output wire (B+ wire) from the generator. Failure to do so can result in injury or damage to the electrical system.

Fig 1: Removing/Installing Secondary Belt

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Remove the secondary accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .

Fig 2: Generator Mounting Components 6.4L
Courtesy of CHRYSLER GROUP, LLC
If required, Remove the secondary generator wiring harness (3) from the intake manifold.
Partially raise the vehicle.
Remove the right front wheel.
Remove the inner splash shield.

Fig 3: Generator, Insulator Cap, B+ Output Terminal & Connector
Courtesy of CHRYSLER GROUP, LLC
Unsnap the plastic insulator cap (4) from the B+ output terminal (2).
Remove the B+ terminal mounting nut (3) at the rear of the generator. Disconnect the terminal from the generator.
Disconnect the field wire connector (1) at the rear of the generator by pushing on the connector tab.

Fig 4: Removing/Installing Secondary Generator
Courtesy of CHRYSLER GROUP, LLC
Remove the front mounting bolts (2).
Remove the side mount bolt (4).

Fig 5: Generator & Heater Hose
Courtesy of CHRYSLER GROUP, LLC
Using care, remove the generator (1) past the heater hose (2).
Remove the generator (3) from vehicle.