Section 892 (Charging (Service Information) 2500 Hd & 3500 Hd): Generator: Installation: 5.7L

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Generator Mounting Bolts 5.7L

Courtesy of CHRYSLER GROUP, LLC

Position the generator (2) to the engine and install the two mounting bolts (2). Tighten to 50 N.m (36 ft. lbs.).
Snap the field wire connector into the rear of the generator.
Install the B+ terminal eyelet to the generator output stud. Tighten mounting nut to 12 N.m (8.8 ft. lbs.).
CAUTION:
Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.

CAUTION:
When installing a serpentine accessory drive belt, the belt must be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or refer to the appropriate belt routing diagram under ACCESSORY DRIVE .
Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
Connect the negative battery cable.