Crankcase Pressure Sensor 2

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Cover, Bolts & Oil Dipstick

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate both of the negative battery cables.
Remove the engine oil dipstick (2).
Remove bolts (1) and the engine cover (3).

Fig 2: Crankcase Pressure Sensor Wire Harness Connector & Clamp
Courtesy of CHRYSLER GROUP, LLC
Disconnect the crankcase pressure sensor wire harness connector (1).

Fig 3: Crankcase Pressure Sensor & Bolt
Courtesy of CHRYSLER GROUP, LLC
Remove bolt (2) and the crankcase pressure sensor (1).