LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 ((Transmission Control Module (TCM) - Electrical Diagnostics - As68RC Automatic Transmission)) >> Standard Procedure >> As68RC Transmission Verification Test >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the following after completion of a diagnostic repair:
    1. Reconnect any disconnected components.
    2. Connect the scan tool to the Data Link Connector (DLC).
    3. With the scan tool, erase all Transmission and Engine DTCs.
    4. With the scan tool, display Transmission Temperature. Start and run the engine until the Transmission Temperature is HOT.
    5. Check the Transmission fluid level and adjust if necessary. Refer to the Appropriate Service Information for the Fluid Fill procedure.
    6. With the scan tool, perform the TCM Quick learn procedure if a transmission component has been replaced, or the TCM has been replaced or flashed. Perform AS68RC TCM Quick Learn.
    7. Road test the vehicle allowing the vehicle to shift through all gears.
    8. Check for DTCs during and after the road test.

    Were there any Diagnostic Trouble Codes (DTCs) set during the road test?

    Yes 

    No 

    • Repair is complete.
scientia non olet · About LEMON Manuals