Sensor, Coolant Temperature: Removal: 6.4L
WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The temperature sensor is located on the front side of the water pump.
- Partially drain the cooling system. Refer to STANDARD PROCEDURE .WARNING:
Hot, pressurized coolant can cause injury by scalding. Cooling system must be partially drained before removing the engine coolant temperature (ECT) sensor.
- Disconnect the electrical connector from the engine coolant temperature (ECT) sensor.
- Remove the ECT sensor from the water pump assembly.